Requirements: Mounting surface
is level and clean (maximum
unevenness of the mounting
flange 0.1 mm).
► Disconnect the system from its voltage supply and secure it
against being switched on again.
► Set the desired position of the SENSORswitch and drill a hole
with a diameter of 25 mm .
► Position mounting flange (B), lining up the center and vertical
axis, and mark the holes (C).
Select and drill the diameter of the holes according to the
see "Recommended screw types",
.
► Select the diameter to match the mounting surface and screw
type.
► Align mounting flange with sensor element (B) and tighten with
screw.
► Place colored cover ring (A) with groove downward and press
close to the button surface.
► Connect SENSORswitch with M12 connection (E).
NOTICE
Mineral grease and oils can attack the plastic of the button!
4
Do not use grease or oils to apply the cover ring (A).
Recommended screw types
■
DIN EN ISO 1207 M4
■
DIN EN ISO 7045 M4
en
