A 2010 / 2001G
•
Symbols affixed to your device may not be removed or covered. Information on the device that is no longer
legible must be replaced immediately.
Read the operating manual before using the device
Pull out the power plug before conducting any maintenance work on the device
Personal protective clothing
-
Wear ear defenders
-
Wear safety goggles
-
Wear a dust protection mask
-
Wear protective gloves
Remaining risks
There will still be residual risks even when the device is used according to the instructions and under observation
of all of the safety notes in this set of operating instructions:
•
Touching the grinding stone surface in the uncovered section.
•
Kickback from work pieces and work piece parts.
When grinding, metal sparks are generated. Caution risk of fire! Keep people and flammable materials away from
sparks.
. Be careful when handling drills. Risk of cuts!
2)
Operation
DANGER! Risk of injury!
The device may only be put into operation if there are no defects. If a part is defective, it
must be replaced before the device is used again.
Check to make sure the device is in a safe operating condition:
-
Check to make sure there are no visible defects.
-
Check to make sure all device components are correctly mounted
-
Be careful when handling drills. Risk of cuts!
NOTICE! Risk of damage to the unit!
Use the rotating switch to set the position of the grinding stone. The further
you rotate the switch in an anti-clockwise direction, the higher the contact pressure. Do not rotate the switch too far,
otherwise the grinding stone will damage the housing.
NOTICE! Risk of damage to the unit! Permit the motor to run for a maximum of three minutes and then cool
down for 7 minutes.
Note: Pre-treat heavily damaged drills by coarsely grinding on a block first.
1.
Plug the device
2.
Insert the drill into the correspondent drill hole (check the
size before to turn on the device)
3.
Use the rotating switch to set the position of the grinding
stone. Turn to "Up" for higher stone, turn to "Down" for
lower stone.
4.
Turn the switch on holding the drill firmly with one hand.
5.
Turn the switch off.
6.
Take out the drill from drill hole.
7.
Check the drill (be aware of the risk of cuts!)
8.
If needed, repeat the operation.
9.
Unplug the device.