8.
9.
Please note: The keep warm temperature cannot be set higher than the
selected heating temperature, i.e. if the selected heating temperature is
set to 160ºF, the keep warm temperature can be set between 110ºF
and 160ºF.
Please note: If the selected heating temperature is set to 212ºF or
200ºF degrees the keep warm temperature cannot be set higher
than 190ºF.
After the selected heating temperature is reached, the display will now
change to the preselected keep warm temperature. The keep warm
symbol and the keep warm temperature are displayed. Once the
water cools to approx. 10ºF below the pre-set keep warm temperature,
the heater will automatically start re-warming the water to the pre-set
temperature. During this time the keep warm symbol will be blinking.
The kettle will keep the selected temperature for up to 40 minutes.
After 40 minutes the keep warm symbol stops blinking indicating
that the heating element has shut off.
Please note: Once you remove the kettle from the power base, all
pre-sets are cancelled.
Tip:
If you want to pour water immediately after brewing and then keep
the rest at a certain temperature, proceed as follows:
• Follow the instructions under chapter 1 or 4.
• Pour the desired amount of water.
• Replace the kettle.
• Select the brewing temperature by pushing the -/+ buttons.
• Push the program button once to show the keep warm display.
• 000ºF. Use the -/+ buttons to select the desired keep warm
temperature.
• Push the On/Off button.
The kettle is now on. Depending on the temperature of the water it will
either re-heat the water immediately or later.
6. CHLORINE REDUCING SETTING / EXTENDED BOIL SETTING
If you boil the water in the default setting, the kettle will shut off 3 seconds
after the sensor registered the boiling temperature. You can prolong the
actual boiling action as follows:
• Set the Chlorine symbol to “CL”, this will add three extra seconds to
the boiling of the water.
• Change the Timer Setting from 003 (seconds) to any duration up to
20 seconds (020).
• Prepare the kettle as explained in chapter 1.
• Before you push the On/Off button, push the program button twice,
the Chlorine symbol appears (Fig. 3c).
• Push either -/+ button once, the display shows “CL”.
• Push the program button again. The display shows the timer symbol and
003 (Fig. 3d).
• Push the -/+ button to select up to 20 seconds.
• Now push the On/Off button. Once the boiling temperature is reached the
kettle will keep boiling the extra three seconds from the CL setting plus the
seconds set with the timer.
Please note: Once you remove the kettle from the base all settings will return
to the default (see Fig. 3a).
7. CLEANING
• Always unplug cord of power base before cleaning.
• Make sure kettle is cold.
• Clean the exterior surface with a clean, damp, soft cloth.
• Never use abrasive cleaners or scouring agents.
• Rinse out kettle.
Attention:
• Over time the stainless steel inside of the kettle may change color slightly.
This is caused by the intense heat of the heating element, especially if the
kettle was turned on repeatedly without water. This will not diminish the
performance of the kettle in any way.
• If your water has a high calcium content, calcium deposits might dull the
inside. Follow the instruction below for decalcification.
