8
12. Always turn the coffee maker off and unplug the power cord from the electrical
outlet when the coffee maker is not in use.
Important:
Always use caution when opening the lid directly after brewing,
or when the heating plate is on. Hot steam can rise from inside the machine
and cause injury if contact with skin is made.
Brewing Small Amounts of Coffee
When brewing small amounts of coffee push the 1-4 cup button (Fig. 2, K) until the
icon illuminates on the display. Then push the ON/OFF button to start brewing. The
brewing process will be slowed down to allow the coffee to reach its maximum
aroma. If you pushed the 1-4 cup button by mistake, push it again to turn off this
function.
Setting Auto-On:
If you want the coffee maker to start brewing at a preset time automatically, first
set the auto-on time by pushing the PROG button (Fig. 2, M). The display shows
"6:00 AM". Push the HR and MIN buttons until the desired auto-on time appears.
Within a few seconds the display will revert to the actual time. You may check
the auto-on time by pressing the PROG button.
Note:
You may cancel the auto-on function by pressing the AUTO button again
until the icon disappears from the display. If you want to change the automatic
start time, follow the steps above to reset.
Once the programed time is set, fill the water tank and filter and place the empty
carafe with the closed lid on the platform. Push the AUTO button (Fig. 2, P) until
the auto-on icon appears on the display. When the time is due the auto-on icon
will go out, while the power icon will illuminate and the unit will start brewing.
Hint:
If you want your coffee at 7:15 AM, set the programmed time to 7:00
(15 minutes earlier). This provides the freshest and hottest coffee possible.
Attention:
• If the machine is unplugged or power is interrupted, all settings described
above must be reset.
• If the machine was set to auto-on and power was interrupted, the machine
will not brew coffee at the programmed time.
Charcoal Filter
This machine comes with one charcoal filter and a charcoal filter holder. You can
brew coffee with or without the water filtration system. Remove the charcoal
filter from polybag. Soak the filter in a glass with cold water for a few minutes.
This will activate the filter. Open the water container lid and remove the charcoal
filter holder. Insert the charcoal filter into the included charcoal filter holder
(Fig. 5) and snap charcoal filter holder closed. Once the charcoal filter is secure,
insert the filter holder down into the designated area inside the water tank (Fig. 3).
The machine will automatically monitor the progress of the filter, and the
illuminated filter icon will appear when it is time to change the filter. When the
filter icon is displayed, remove the charcoal filter holder and replace the charcoal
filter. Insert the charcoal filter holder back into the water tank. Push and hold the
filter button until the filter icon disappears. The filter counter is now reset.
Replacement charcoal filters can be purchased through the website.
IMPORTANT:
Do not use charcoal filter for longer than recommended. Change
the charcoal filter as advised for best tasting coffee.
