5
Before First Use
After unpacking your coffee maker
clean all the loose parts with warm
water and make yourself familiar with
the different functions. After reading
these instructions, clean the internal
parts of the machine by making two
carafes using only water, without any
ground coffee inside the filter.
Setting the Clock
1. When you plug the coffee maker
into the outlet the LCD will display
“AM12:00” and the colon will flash.
All indicator lights will be off.
2. Press the PROG button one time,
the word CLOCK will be shown in
the upper right corner of the
display. (Fig. 3).
3. Push and hold the HOUR button.
The hours will advance. The display
will show AM and PM. When the
correct hour is displayed release
the button and push and hold the
MIN button to set the minutes.
Attention
: You must change the
clock when the time changes
(Standard Time, Daylight Savings
Time).
4. When correct time is displayed,
press the PROG button two times
to exit the programming mode.
Automatic Start Function
If you want the coffee maker to start
brewing at a preset time automatically,
set the automatic start function as
follows:
1. Press PROG button twice and the
word TIMER will be shown in the
upper left corner of the display.
(Fig. 4).
2. Set the delayed starting time by
pressing HOUR and MIN button
repetitively until the desired time is
displayed. Press PROG button
once to exit programming mode.
3. Press ON/OFF button twice, the
indicator light for AUTO is illumi-
nated green. You may check the
automatic start time by pressing
PROG twice.
Note:
You may cancel the auto
matic start function by pressing
ON/OFF. If you want to change the
automatic start time, follow the
steps above to reset.
When the time is due the indicator
of AUTO will go out, while the
indicator of RUN will illuminate red
and the unit will start brewing.
Using Your Coffee Maker
Coffee makers produce very hot water.
If you follow the sequence as de-
scribed below you will avoid possible
accidents which might cause severe
injuries and burns.
1. Remove carafe from machine and
fill carafe with desired amount of
water.
Note:
Water will be absorbed during
brewing process. The brewed coffee
will be slightly less than markings
on carafe.
2. Open the water container lid (Fig. 1,
A) and fill the water tank (Fig. 1, E)
with water.
Caution:
The water level
should not exceed MAX level
marked on the water level indicator
on the side of the machine. If you fill
too much water into the water tank
the carafe may overflow with hot
coffee.
3. Make sure the filter holder (Fig. 1, D)
sits firmly in the filter holder hous-
ing. Then place the GoldTone filter
(Fig. 1, C) into the filter holder and
ensure it fits correctly.
Note:
A size 4 paper filter can also
be used instead of the GoldTone
filter. Always fold the bottom and
Fig. 3 Fig. 4
7:10
8:45
CLOCK TIMER
