Caple ZEL900, Инструкция по эксплуатации

Страница: 11 / 24

Instruction manual ZEL900 ZEL900GM 11
Please keep this instruction manual for future reference
I N S TA L L AT I O N - D U C T E D
WARNING:
Observe the warning concerning the operation of the appliance when air is discharged from
the room.
When the cooker hood and appliance supplied with energy other than electricity are
simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4×10-5 Bar)
Drill 3 x 8mm holes to accommodate the bracket. Screw and tighten the bracket onto the wall with
the screws and screw plugs provided.
Level up the cooker hood and hang onto the wall bracket hook.
5


 

 




         





            










2
1 Installation (Vent outside):
Attention! Observe the warning in the instruction sheet concerning the
operation of the appliance when air is discharged from the room.
1. Drill 3 holes to accommodate the bracket. Screw and tighten the bracket onto the
wall with the screws & wall plugs provided.
2. Lift up the cooker hood and hang onto the wall bracket hook .
Holes on wall
Screw Plug
Wall Bracket
Screw
(4mm x 30mm)