Instruction manual WMi3000 / WMi3005
Please keep this instruction manual for future reference
30
The Service panel proceed as follows:
P.25
P.24
Cleaning & Maintenance
Pull out the power plug to avoid electrical shock before washing.
After using the washing machine, pull out the power cord and close the door tightly to avoid
potential harm.
Remove foreign matters
Drain Pump Filter:
Drain pump filter can filter small foreign matters from the washings.
Clean the filter periodically to ensure the normal operation of the washing machine
.
According to the soil level within the cycles and the frequency of the cycles, you have to inspect
and clean the filter regularly.
The pump should be inspected if the machine does not empty and/or spin;
The machine makes an unusual noise during draining due to objects such as safety pins, coins
etc. blocking the pump.
The Service_panel proceed as follows:
Warning!
When the appliance is in use and depending on the programme selected there can be hot water in
the
pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished
the cycle, and is empty. When replacing the cover, ensure it is securely tightend
.
2.Turn the filter down as
shown with the figure and
take out sundries matters.
1.After the power is dis-
connected, pull out the
Dam-Board.
3.Reinstall each part back
after sundries matters are
removed.
Dam-Board
Cleaning & Maintenance
Clean detergent box and grooves
Clean detergent drawer and grooves
1.Press down the arrow location on softener cover
inside the drawer.
2.Lift the clip up and take out softener cover and wash
all grooves with water.
3.Restore the softener cover and push the drawer into
position.
Clean inlet filter
Inlet filter must be cleaned if there is not any or
insufficient water in when the tap is opened.
Clean the tap filter:
1.Close the tap.
2.Select any procedure except “Wash” or “Drain”
procedure.
3.Press the button “Start/Pause” and keep the
procedure running for about 40 seconds.
4.Remove the inlet pipe from the tap.
5.Use water to wash the filter.
6.Reconnect the inlet pipe.
Washing the filter in washing machine:
1.Screw off the inlet pipe from the backside of the
machine.
2.Pull out the filter with long nose pliers and reinstall
it back after being washed.
3.Reconnect the inlet pipe.
4.Open the tap and make sure there is no water leakage.
5.Close the tap.
Notes: Generally, the tap filter is washed first and then the filter in washing machine will be washed.
If only the filter in washing machine is washed, then the steps 1~3 in cleaning the tap filter shall be
repeated.
1. After the power is
disconnected, pull out
the Dam-Board.
2. Turn the filter down as
shown with the figure
and take out sundries
matters.
3. Reinstall each part
back after sundries
matters are removed.
WARNING
When the appliance is in use and depending on the
programme selected there can be hot water in the pump.
Never remove the pump cover during a wash cycle, always
wait until the appliance has finished the cycle, and is empty.
When replacing the cover, ensure it is securely tightend.
