Caple WI6126, Техническая информация

Страница: 25 / 31

19
Fig.29
a. As to the sensor in the point A, remove the air-duct board firstly (Page 4), and remove the fixing screw, then take off the
sensor, and then unplug another socket X 1 of the sensor in the PCB control penal board in the (Fig.7) , and it can be
replace it with the
same model.
b.As to the sensor in the point A1, there are two installation method.As the diagram below
(Fig.30 & Fig.30.1 )
◎
The new installation version
’
s sensor: remove two fixing screws 1 with the philip head screw dryer, and remove
the sensor cover 2 and draw the sensor 4 from the sensor cover slightly, and then unplug the Housing 3, it can be
replaced with the same model
’
s sensor.
◎
The old installation version
’
s sensor: remove the air-duct board (page 6) , and take off the fixing screw(1) , and take
off the sensor, and unplug another terminal
’
s from socket X1 (Fig.7 ) in the PCB board, and replace the sensor with the
same model
’
s (Fig.30.1 ) .
Fig.30 Fig.30.1
3 >
．
Refrigeration compartment sensor.
Refrigeration compartment sensor is located on (B) of (Fig.29) . It has two different installations with 2 different
replacements. The replacement is similar with (A1) See (Fig.30& Fig.30.1)
4 > The solutions above are not good enough, we recommend a better and faster method for you, this method is apply
for the below situation.
a. The sensor of the freezing position (A). (Fig.29)
b. The sensor of the refrigerator position,old installation method. (Fig.30.1)
Replacement: (Fig.31)
a. Take off the sensor of the fixing screw, and draw the sensor off , and cut in the end. (A)
b. Tear off the wire 50MM after cuting it off, in the end tear 12mm off,. (B)