5
•
Remove 2 screws •, then pull door
•
as per arrowhead direction and you will remove the door.
Please remove bottom hinge (Right)
•
as well for the assembly. (Fig.A & Fig.B)
•
Remove 3 screws
•
of right upper Hinge, then remove right upper
•
& Right lower hinges
•
; (See
fig.C)
•
Use the screws which you removed From right side hinges to fix left upper & bottom hinges
••
(See Fig.D & Fig.E)
•
Rotate door at 180 degrees then assemble the door as per the reverse way of removal
Fitting a kitchen plinth
These models are recessed to fit a kitchen plinth. A H50mm vent slot is required in the plinth to ensure air is
able to ventilate correctly.
See diagram below.
Failure to include this vent slot will invalidate the guarantee.
5
0
m
m
490mm
R2
5m
m
DEFROSTING/CONDENSATION
Your wine cabinet is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the
refrigerated surface of the wine cabinet (interior rear wall) defrosts automatically. The defrost water
is channeled into a drain pan which is located at the back of the wine cabinet next to the
compressor from where it evaporates.
（注意修改）
HUMIDITY MAINTENANCE SYSTEM
The wine cabinet is equipped with a system for maintaining the correct level of humidity. If humidity
