3
OPERATING INSTRUCTIONS
The wine cabinet should be placed where the ambient temperature is between 5-35 deg
centigrade (41-95 degrees Fahrenheit). If the ambient temperature is above or below this range,
the performance of the unit may be affected. For example, placing your unit in extreme cold or hot
conditions may cause interior temperatures to fluctuate and the range of 5-18 ºC (41-65 degrees
Fahrenheit) may not be reached.
•
RUN
Indicator light illuminates to signify the cooling cycle is currently in operation.
•
“LIGHT” Button
To control the interior light, on/off.
•
“LIGHT”
To control the interior light, on/off.
•
“Power”
To control this unit power, on/off. (Press and hold this button for approximately 3 seconds);
•
“UP” Button
To raise (warm) the temperature in 1 ºC stages.
•
“DOWN” Button
To lower (cool) the temperature in 1 ºC stages.
Setting the Temperature Control
•
You can set the temperature as you desire by pressing the UP or DOWN buttons. When you
press either of the two buttons for the first time, the LED readout will show the original
temperature set at previous time
For Wi151: The temperature preset at the factory is 12 ºC.
•
The temperature that you desire to set will increase by 1ºC if you press the UP button once, and
will decrease 1ºC if you press the DOWN button once.
•
The temperature selected will flash in the LED display for approximately 5 seconds, and will then
display the actual temperature (which will gradually reach the set temperature).
•
To view the “set” temperature, press the UP or DOWN button, then the LED display will “flash”
for 5 seconds to show the “set” temperature.
NOTE:
To temporarily disconnect (stop) the cooling cycle, you must disconnect the power cord from the
electrical outlet. NOTE: There is no “OFF” position on the electronic control panel. When
disengaging cooling operation for long periods of time, leave the door partially open to prevent
mould/mildew from forming inside the cabinet.
NOTE:
