Instruction manual WDU060, WDU080 & WDU125
10
Please keep this instruction manual for future reference
E L E C T R I C A L C O N N E C T I O N S
13 AMP FUSED
DOUBLE POLE
SWITCHED SPUR
WALL MOUNTED
PLUG SOCKET
ELECTRICAL CONNECTION FOR
DISPOSER PROVIDED WITH PRE-
WIRED MOLDED PLUG AND LEAD
.
For Continuous Feed Only - Not Batch Feed
4A
13 AMP FUSED
DOUBLE POLE
SWITCHED SPUR
WALL MOUNTED
13 AMP FUSED
SPUR MOUNTED
UNDER SINK
4B
W H E N U S I N G T H E AT TA C H E D
P R E - W I R E D M O L D E D P L U G A N D L E A D
( S E E 4 A ) .
This waste disposer is engineered to be connected
to a 220/240v~-50/60 Hz electrical supply
through the attached three-pin plug and into a
wired Socket. The disposer must be protected
by a BS 1363 13Amp fuse. The fuse is included
within the molded plug and lead, attached to the
Disposer.
The 13 amp double pole switched spur switch
should be positioned higher than the sink worktop
and at a minimum of one meter from the side of
the sink, away from water splashes and out of
the reach of children. This spur switch must be a
double pole with at least 3mm contact separation
In each pole. 20Amp DP switches BS 3676 meet
this condition.
W A R N I N G :
This appliance must be earthed. In the event of a malfunction, Earthing provides a path of least
Resistance for the electrical current, Thus reducing the risk of electrical Shock.
The rating for this disposer is 220/240V~, 50/60 Hz and should be connected to a main
distribution board or consumer unit.
Prior to connecting the electrical supply, the installer must be thoroughly familiar with electrical
power and procedures. If the installer is not, an electrician should be contacted.
