J130
2
INSTALLATION
- When installed the hood must not be less than
60 cm. above electric burners or 65 cm. above
gas or mixed burners.
If the instructions for the installation of the gas
cooking appliance specify a greater distance,
please take this into account.
Electrical Connection
- Before making the electrical connection, make
sure that the voltage of the electrical mains com-
plies with the value indicated on the rating sticker.
It is highly recommended that the connection be
made by a qualified electrician.
Unit Fitted with Plug
Insert the plug into an outlet that complies with the
electrical safety codes currently in effect.
Once inserted into the outlet, the plug must be
easily accessible. If you intend to connect the unit
directly to the electrical mains, remove the plug
and install a standard bipolar switch with a mini-
mum contact break of 3 mm.
Unit Not Fitted with a Plug
Install a standard plug or a standard bipolar
switch with a minimum contact break of 3 mm.
The manufacturer will not be held liable for any
problems arising out of the failure to comply with
the foregoing instructions.
CLASS 2 APPLIANCES DO NOT HAVE TO BE
EARTHED
Class 2 appliances labelled with the symbol in the
form of a double square must be connected as
follows:
BROWN
=
L
(current)
BLUE
=
N
(neutral)
UTILIZATION
The hood is designed to be utilized either for
suction version at external evacuation or filtering
version at internal recirculation.
SUCTION VERSION
EXTERNAL EXHAUST
The air is vented outdoors by a duct which must
be connected to exhaust hole Ø 120 mm. by the
connecting ring (A) Fig.1. The hood must not be
connected to fuel exaust flues or to a duct in which
hot air is circulated, or is utilized to remove the
fumes from appliances stocked by an energy
different from the electric one. Pay attention when
there is the contemporary functioning of an hood
and a burner or furnace depending from the air
of the surrounding (stocked by an energy different
from the electric one), because the hood,
suctioning, takes away from the surrounding the
air that the burner or the furnace need for the
combustion.
So, for a sure functioning, provide a suitable
ventilation of the room by doors, windows or other
technical devices.
For the external exhaust you have to follow the
Authoritys rules. The external exhaust must not be
made in a flue, utilized for the combustible gas of
appliances not stocked by the electric energy.
FILTERING VERSION
INTERNAL RECYCLING
When there is no exhaust duct for venting
outdoors, you can use a carbon filter. The air is
depurated by the filter and put again in the
surrounding. To use the appliance in this version,
proceded as follows:
-Insert the carbon filter "D" Fig. 2.
The air is vented outdoors by a duct Ø 120 mm.
passig through the wall units and connected to
the connecting ring (A).
MOUNTING THE HOOD
Once the hood has been set up to vent or
recirculate the air, proceed with the installation
process.
- This appliance is designed to be installed within
a cabinet or other supporting structure.
- The cutout which must be made on the bottom
of the cabinet must have the dimensions shown
in Figure 4.
Tho mount the hood, proceed as follows:
- Remove the frame by pushing the buttons "B"
Fig. 3.
*Note: For the version with halogen
lamps,switch off the connectors "F" Fig. 3.1.
- Insert the hood into the cutout.
- Insert the screws supplied with the hood intro
the "C" holes and tighten the hood to the cabinet
(Fig. 4).
- Remount the frame
*Note: For the version with halogen lamps,
connect the spot lights before remounting the
frame.
All manuals and user guides at all-guides.com
