Caple S-DD2, Инструкция по эксплуатации

Страница: 8 / 15

1
Model S.DD2 STANDARD VERSION
A: Extraction panel down/OFF switch
This serves to close the extraction panel either completely or in intermediate positions above
180 mm from the cook top. When the extraction panel is being closed, it will remain in opera-
tion until it reaches 180 mm above the cook top. Below this height, the extraction function will
switch off automatically.
B: Extraction panel up ON/Speed 1
This serves to bring the extraction panel up to a maximum height of 00 mm and to auto-
matically set the first extraction speed when the panel reaches a height of 180 mm. Pressing
the button when this height is reached makes it possible to place the extraction panel in the
required intermediate positions, up to a maximum of 00 mm, while leaving the extraction
speed of the motor unchanged.
C: Speed 2 switch
D: Speed 3 switch
E: Speed 4 switch
These serve to set the respective suction speeds after the extraction panel has reached 180 mm
above the cook top and to set the height of the extraction panel to a maximum of 00 mm by
pressing the same button.
F: 10-minute timer
This is used to switch off the extraction system automatically as well as to close the extraction
panel 10 minutes after it has been enabled.
Model SDD2 TOUCH CONTROL VERSION (Fig. 1)
OFF switch: (Fig. 1) It is used to close the aspiration panel completely or to position it at inter-
mediate heights at least mm 180 above the cooktop. While closing the aspiration panel keeps
on working at the speed set up to the height of mm 180 from the cooktop. Below this height
the aspiration function is automatically cut out.
On : (Fig. 1) It is used to extract the aspiration panel up to the maximum height of
mm. 00 and to set automatically the first aspiration speed when reaching the height of mm
180 from the cooktop.
When pressing the button again after reaching this height, the aspiration motor speed can be
encreased.
If the aspiration panel is positioned at an intermediate height between mm 180 and mm 00, the
aspiration panel can start raising again by pressing first the OFF switch and then the On/+.
Switch.
Leds:
(Fig. 1) The different speed levels are indicated by blue leds. (1. Speed level corresponds
to the led down on the left).
MINUS SWITCH: (Dis. 15) it is working only if the position reached by the aspiration panel
is higher than mm 180 from the cooktop. It is used to decrease the aspiration motor
speed.
TIMER SWITCH:
(Fig. 1) : it is used to stop automatically the aspiration system and to close
automatically the aspiration panel ten minutes it has been set.
3/ HOW THE HOOD WORKS
GB