Instruction manual RiL1795
Please keep this instruction manual for future reference
22
ENERGY SAVING TIPS
1. Install the appliance in a cool, well ventilated room, but not in direct sunlight
and not near a heat source (radiator, cooker.. etc). Otherwise use an insulating
plate.
2. Allow warm food and drinks to cool down outside the appliance.
3. Cover drinks or other liquids when placing them in the appliance otherwise
humidity increases in the appliance. Therefore, the working time gets longer.
Also covering drinks and other liquids helps to preserve smell and taste.
4. Try to avoid keeping the doors open for long periods or opening the doors too
frequently as warm air will enter the cabinet and cause the compressor to switch
on unnecessarily often.
5. Keep the covers of the different temperature compartments
(crisper, chiller ...etc) closed.
6. Door gasket must be clean and pliable. Replace gaskets if worn.
INSTALLATION INSTRUCTIONS
Before installation, read the instructions carefully. Fit the refrigerator/freezer in
stable kitchen units only. If necessary, reverse the door according to instructions.
1. See fig.A for the necessary installation components.
2. Unscrew two screws at the top surface. Fig.D
3. Peel the double sided tape at the bottom surface of trim flap1.
4. Insert trim
flap
1
into slot and screw by 2
screws
6
to left/right side. Fig.E
IMPORTANT NOTICE:
Do not screw into the middle hole.
5. Pass the power cord through ventilation shaft and position it so that the
appliance could be easily plugged in once it has been installed. Fig.B - fig.C.
6. Take out the
trim gasket
4
located on the side panel of the appliance and
stick it on reverse side of the door hinges of the appliance. Fig.E - fig.F
7. Raise the appliance and slide into the kitchen unit.
8. Push the appliance to the reverse side of the door hinges providing that the
trim gasket
2
covers the space between the appliance and the kitchen unit.
9. Align the front feet with front surface of the kitchen unit. Fig.G
RIL1795_Larder Instruction Manual.indd 22
07/02/2017 10:35
