34
35
Instruction manual Ri7301
Instruction manual Ri7301
Please keep this instruction manual for future reference
Please keep this instruction manual for future reference
R E C O M M E N DAT I O N S
› If the appliance is switched off or unplugged, wait at least 5 minutes before plugging the
appliance in or restarting it in order to prevent damage to the compressor.
› The cooling unit of your refrigerator is located at the rear of the appliance. Therefore, water
droplets or ice may form on the rear surface of your fridge due to the operation of the
compressor at specified intervals. This is normal, there is no need to perform a defrosting
operation unless there is excessive ice.
› The appliance you have purchased is designed for domestic use only. It is not suitable
for commercial or common use. If the consumer uses the appliance in a way that does
not comply with this, we emphasise that the manufacturer and the dealer will not be
responsible for any repair and failure within the guarantee period.
If the problem persists ore more help is required, please contact our Caple service team on
0117 938 7420
or via email
E N E R G Y S AV I N G T I P S
1. Install the appliance in a cool, well ventilated room, but not in direct sunlight and not near
a heat source (such as a radiator or oven) otherwise an insulating plate should be used.
2. Allow warm food and drinks to cool before placing them inside the appliance.
3. Place thawing food in the refrigerator compartment. The low temperature of the frozen
food will help cool the refrigerator compartment while the food is thawing. This will save
energy. Frozen food left to thaw outside of the appliance will result in a waste of energy.
4. Drinks or other liquids should be covered when inside the appliance. If left uncovered,
the humidity inside the appliance will increase, therefore the appliance uses more energy.
Keeping drinks and other liquids covered helps preserve their smell and taste.
5. Avoid keeping the doors open for long periods and opening the doors too frequently as
warm air will enter the appliance and cause the compressor to switch on
unnecessarily often.
6. Keep the covers of the different temperature compartments ( such as the crisper and
chiller) closed.
7. The door gasket must be clean and pliable. Replace gaskets if worn.
