15
A forgotten dish can be added at any time before the detergent cup opens.
Open the door a little to stop the washing.
After the spray arms stop working, you can open the door
completely.
Load the forgotten dishes.
Close the door, the dishwasher will start running again
after 10 seconds.
4
3
2
1
It is dangerous to open the door when washing,because the hot water may scald you.
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Turning on the Appliance
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and push them back.
It is commended that loading the lower basket first, than the upper one
(see the section entitled “Loading the Dishwasher”).
Pour in the detergent (see the section entitled “Salt, Detergent and Rinse Aid”).
Insert the plug into the socket. The power supply is 220-240 VAC 50 HZ, the
specification of the socket is 10 A 250 VAC.
Make sure that the water supply is turned on to full pressure.
1
2
3
4
Turn the program knob in clockwise direction, the wash program will
change as follows direction
When Turn the program knob in counterclockwise direction, the wash
program will change as follows direction
When a program is selected , the response light will light. Then press the
Start/reset button, the program is running.
Premise: A cycle that is underway can only be modified if ithas only been running
for a short time. Otherwise, the detergent May have already been released, and the
appliance may have already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled " Loading the Detergent " ).
Press start/reset button more than three seconds the machine will be in stand by
state ,then you can change the program to the desired cycle setting (see the
section entitled " Starting a wash cycle. . . " ).
NOTE: If you open the door when washing, the machine will pause. When you
close the door and press the start/reset button, the machine will keep on working
after 10 seconds.
The program lights shows the state of the dishwasher:
a) One of the program lights on
--> stand by
b) One of the program lights on
--> pause
c) One of the program lights blinking
--> run
d)some of the left three program lights fast blinking
error
-->
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.
NOTE:
