Caple DD605BK, Инструкция по эксплуатации

Страница: 10 / 20

1 0
Electrical connection
If the appliance has no plug or if the plug is not
easily accessible, then a device needs to be
fitted to cut it off from the electric network;
this device must have an opening distance
between contacts on all poles of at least 3 mm.
Electrical connection
While installing the appliance and carrying out
maintenance operation, make sure it is
disconnected from the electrical network or
the fuses are cut out or removed.
Check that:
t
The power is enough
t
The feeder lines (mains) are in good condition.
t 5IFDBCMFTEJBNFUFSDPNQMJFTXJUIJOTUBM
lation
regulations
WARNING
Place the metal box containing the electronic
components at a distance of no less than
65cm from gas operated
hobs or in any case,
65cm from the suctioning sur f ace of the
cookerhood.
NOTE
We recommend installing the metal box
containing the electronic components at least
10cm above floor level and at a suitable
distance from all heat sources (e.g. oven sides
or
hob ).
CAUTION
This appliance is fitted with an H05 VVF 3
conductor, 0.75 mm2 (neutral, phase, and
ground) power cord.
This can be connected up to a 220 - 240 V
monophase electrical network through a
CEI 60083 approved power socket, which
must remain accessible after installation, in
compliance with installation regulations. We
decline any responsibility in case of accidents
caused by a lack of ground connection or
incorrect ground connection. The appliance
must be fed through a differential protection
device (RCD), with a nominal residual current
not exceeding 30mA. If the power cord is
damaged, call the
Caple after-sales service to
avoid any risk.
WARNING
The downdraft connection to the electrical
network must be carried out only by
professional and qualified technicians.
The downdraft must be connected to a
properly installed and suitable electrical
network.
The electrical system must comply with
VDE0100 standard.
DANGER
If the cooker hood presents any
anomaly, disconnect the appliance or
remove the fuse corresponding to the
appliance power disconnecting line.
NOTE
This appliance complies with the
European Directives 2006/95/EC (Low
Voltage Direc-tive) and 2004/108/EC
(Electromagnetic Compatibility).