8
INSTALLATION
5 mm
50 min.
Min. 4
20-40
Max. 50
ATTENTION:
To guarantee a correct functioning of the appliance it is important to
provide the work surface, during the installation, of a 4mm chink for
the length of the recess on the front side of the furniture.
This, because the electrical controls have a guard which,
if the
electronic system overcome a 94°C temperature, switches off
the hob until the temperature return under the limit.
So during
the functioning, to guarantee a rush of air which maintains the right
temperature, a fan start up.
Provide the assembling with an underlying cover which ensures
the rush of air from the back side of the forniture or, if the hob is
installed over an oven, a suitable insulation to guarantee that the
temperature do not overcome 85°C.
If this happens there can be damages to the electronic system, for
which the manufacturer do not have responsibilities.
Electrical connection.
•
The appliance must be installed by a qualified
technician, who knows safety and assembling
rules in force. In particular, local power institution
rules must be observed.
•
Check that the voltage indicated in the appliance
indicator plate corresponds to the voltage used in
your house. The indicator plate is placed in the
back side of the hob.
•
The grounding is compulsory according to the law.
All the electric wires and grounding conductors
should have appropriate dimensions.
•
The manufacturer declines all responsibility
for damages on person or things caused by
the non-observance of rules written above.
•
The electrical connection between the hob and
a possible embedding oven must be realized
separated, whether for electrical safety
reasons, or to simplify the extraction of the
appliances.
In the case of a direct connection to the net, it
is neccesary to interpose a mono-pole switch
between the appliance and the net , with a minimal
3mm opening between the contacts.
The installer is responsible of the right electrical
connection and of the safety rules compliance.
Before effecting the connection, make sure that:
•
the outlet has the grounding and is make
according to law;
•
the outlet could bear the highest load of the
machine, shown in the indicator placed on the
appliance;
•
the charging voltage is included in the
characteristics indicator;
•
the outlet is plug-compatible with the appliance.
On the contrary replace the outlet or the plug; do
not use extansions or multiplexes;
•
the grounding wire (yellow/green coloured)
is connected to the terminal board on the point
indicated with the respective sign, and is longer
than other conductor wires;
•
the cable must not undergo foldings or
compressions;
•
the cable must be periodically controlled and
changed only by authorized technicians.
•
the firm declines all responsabilities if these
rules are not respected.
