gas adustment
Ŷ7DNHSUHFDXWLRQVRQWKHRSHUDWLRQVDQGDGMXVWPHQWVWREHFDUULHGRXWZKHQ
FRQYHUWLQJIURPRQHJDVWRDQRWKHU
Ŷ$OOZRUNPXVWEHFDUULHGRXWE\DTXDOL¿HGWHFKQLFLDQ
Ŷ%HIRUH\RXEHJLQWXUQRIIWKHJDVDQGHOHFWULFLW\VXSSO\WRWKHDSSOLDQFH
&KDQJHWKHLQMHFWRURIWKHEXUQHUV
1
Remove the pan support, Burner lid and Flame spreader.
Unscrew the injector using a 7 mm box spanner and replace it with
the stipulated injector for new gas supply.
Carefully reassemble the all components.
After injectors are replaced, it is advisable to strongly tighten the
injector in place.
2
Injector
Control handle
Tap
Sealing ring
Tap
by-pass screw
Ŷ'RQRWGLVPDQWOHWKHWDSVKDIW
Ŷ%HIRUHSODFLQJWKHEXUQHUV
QRWEORFNHG
Ŷ$IXOORSHUDWLRQDOWHVWDQGDWHVW
VXFKDVVRDSZDWHURUJDV
DTXDOL¿HGWHFKQLFLDQRULQVWDOOHU
KDVWRPDUN³9´
RQWKHULJKWJDV
FDWHJRU\WRPDWFKZLWKWKH
LQUDWLQJSODWH
5HPRYHWKHSUHYLRXV
VHWWLQJ³9´PDUN
LQWKHHYHQWRIDPDOIXQFWLRQ
FKDQJHWKHZKROHWDS
EDFNRQWKHWRSSODFHPDNHVXUH
WKDWWKHLQMHFWRULV
IRUSRVVLEOHOHDNDJHVPXVWEH
FDUULHGRXWDIWHUJDVFRQYHUVLRQ
Ŷ$IWHUFRPSOHWLQJFRQYHUVLRQ
VHWWLQJ
GHWHFWRU
G20/20mbar
50/60Hz,Pmax 2W
G20 20mbar
G30/29mbar
G31/37mbar
GB
Cat.:
II 2H3
+
Qn G20:
G30:
G31:
S/N:
/
Model:
Tuurn the taps down to minimum
R
Remove the knob from the tap and place a small
‐
‐
‐
turning
does then remove the control knob and make further
from maximum flow to minimum flow. If it
Adjustmen
nt of minimum le
evel of the flame
e
bladed screwdriver in the centre of the tap shaft.
The correct adjustment is obtained when the flame
has a length of about 3 - 4 mm.
/
must be tightly screwed in.
For butane propane gas, the adjusting screw
Refit the control knob.
ake sure that the flame does not go out by quickly
M
adjustments to the gas flow, testing it again once the
adjustment has been made.
Repeat this process for each one of the gas taps.
110-240V
2
1