Capital CG30RFS-NG, Инструкция по использованию и уходу, Страница: 11 / 42

4
FLEXIBLE HOSE
If a flexible hose is used to connect to the inlet, it should be as short as possible with a maximum length of 1.5
metres;
o
The flexible connection must be approved to class B or D of AS/NZS1869 as a minimum.
o
it should not be bent, kinked or compressed;
o
it should not be in contact with the rear wall of the appliance or in any case with parts which may reach a
temperature of 50°C;
o
it should not come into contact with pointed parts or sharp corners;
o
it should not be subject to any pulling or twisting forces;
o
it should be easy to inspect along its entire length in order to be able to check its condition.
o
The supply connection point must be accessible with the appliance installed.
o
The inner diameters of the pipe are as follows:
8 mm for LPG;
13 mm for Natural Gas.
Ensure that the gap between the probe and the surface of the rear burner is 3mm.
POST INSTALLATION CHECKS
Perform post installation checks and ensure proper and safe operation before leaving. If you cannot achieve
satisfactory performance, contact the service centre
Test all burners individually and in combination. Instruct the user and leave all documentation with the user before
leaving.
REAR BURNER
suitable to be fixed to the wall within 50 mm of each connection point. The length of the
tether shall not exceed 80% of the length of the hose assembly.
Restraining tether for cart/trolley models
a restraining tether of adequate strength shall be fixed to the appliance and be
Where a mobile appliance is to be connected to a fixed gas supply