
Contour 5W Series Manual
© Capital Fireplaces 2018
19
Maintenance
Installation Instructions
Fire Brick Assembly
1. Place Throat Plate Fireboard against the roof of the firebox and slide forward over the
location pins then fix in position by slotting the Retaining Plate under it with the lip facing down.
2. Place Top Fireboard in position on its retainers.
3. Put the two Rear Fireboards back into position before refitting the screws.
4. Lastly reposition the Side Fireboards one at a time using the Side Bolts to keep them in place.
Fire Brick Removal
1. Remove the two screws holding the rear
boards in place, the two rear fireboards
can be removed by pulling out from the
middle.
2. Remove both Side Bolts from inside the
firebox to free the top of the Side
Fireboards, remove these carefully as
they are very fragile.
3. Lift the Top Fireboard up to slide it off its
retainers and remove.
4. Remove the Retaining Plate by pulling
towards you to get it off the retainers
each side. You can now slide the Throat
Plate Fireboard backwards, then
forward to allow it to drop out.
5. Firebox is now ready to clean.
NOTE:
All screws removed at this time must
be renewed.
Recommended Periodic Checks
If you discover any issues or require replacement parts, please call your retailer / installer.