Canworld CDE500 Series, Руководство пользователя

Страница: 85 / 284

CDE500 Vector Control AC Drive Chapter 5 Parameter List Table
-72-
Function
Code Name Range Default Step Description
C5.09
①
VY1 function 0~45 0 1 Same As C1.01
C5.10 ① VY2 function 0~45 0 1 Same As C1.01
C5.11 ① VY3 function 0~45 0 1 Same As C1.01
C5.12
①
VY4 function 0~45 0 1 Same As C1.01
C5.13 VY1 output delay time 0.0~3600.0 0.0 0.1Sec
C5.14 VY2 output delay time 0.0~3600.0 0.0 0.1Sec
C5.15 VY3 output delay time 0.0~3600.0 0.0 0.1Sec
C5.16 VY4 output delay time 0.0~3600.0 0.0 0.1Sec
C5.17 VY terminal active
state logic 0000~1111 0000 1 0: Positive logic
1: Negative logic
Unit's digit: VY1 Ten's digit: VY2 Hundred's digit: VY3 Thousand's digit: VY4
d0 Motor Control
Function
Code Name Range Default Step Description
d0.00 ① Motor control mode 0~2 0 1
0: V/f 1: Open loop vector control 2: Close loop vector control
d0.01 Carrier frequency Module
dependent Module
dependent 0.1kHz
d0.02 Carrier frequency
adjustment with
temperature 0~1 1 1 0: Enabled
1: Disabled
d0.03 Random PWM depth 0~10 0 1
Random PWM can decrease motor noise without increasing carrier frequency. The bigger , the wider spectrum.
0: disable random PWM 1~10: setting the depth of random PWM
d0.04 DPWM switchover
frequency upper limit 0.00~b0.00 50.00 0.01Hz
If the output frequency is higher than this Value + 3Hz, the DPWM modulation mode is adopted, or else
continuous method is adopted.
d0.05 PWM Modulation
mode 0~1 0 1
0: Asynchronous modulation 1: Synchronous modulation
d0.06 Torque boost 0.0~20.0
Module
dependent
0.1%
0.0%: auto torque boost
> 0.0%: customized
torque boost
d0.07 ① Cut-off frequency of
torque boost 0.00~b0.00 37.00 0.01Hz