SIBLEY
®
600 TWIN ULTIMATE
SIBLEY
®
600 TWIN ULTIMATE PRO
SETUP INSTRUCTIONS
2
8
Get the A frames and loosen one of the sides next to the
top which means both of the sides of the A frame can be put
next to each other making it much easier to manoeuvre inside
the tent. Unzip the front door and put the first A frame in place
inside it. Position the feet of the A frame just off the ground-
sheet and then push them against the side of the groundsheet.
This positions them correctly and helps stop them sliding out
of position.
9
Now it’s time to fit the two central poles and the cross bar.
This is the only bit of the build that really needs two people.
Saying that we did it with one but it’s a bit of a balancing act
getting both poles up at the same time while keeping them
lined up.
10
Leave the tent and zip up the door. Using the large pegs,
attach the first guy rope above the door. And then work your
way around the tent pegging in the guyropes.
N.B.
• All the guy ropes need to follow the lines of the
seams in the roof.
• Adjust the guy rope slider so you have approx 50cm
of loop to the peg - this allows adjustment in both
directions.
• It is important to make sure the tent stays symmetri-
cal and that the tension is evenly spread.
Adjust the tension on the guy ropes to make sure the tension
is evenly spread.
If the door seems too tight move the two guy
ropes either side of the door in towards the middle of
the door to relieve some tension.
TIP
8
11
9
