1
1
3
2
Step 1
Requires:
Pencil, Level and Shelf (1)
Use shelf as a guide to mark where screws (2) will be secured to wall.
Note: You may opt to use a level (not included) to verify the markings are straight.
Step 2
Requires:
Power Drill and 3/32” (2.4 mm) Bit, Cross-head Screwdriver, Shelf (1),
Installation screws (2) and Drywall Anchors (3) (if no studs)
Use the power drill and 3/32” (2.4 mm) drill bit to drill holes at marks. Use the power drill with a
cross-head bit or cross-head screwdriver to drive the installation screws (2) into studs or an-
chors. Leave a 1/8” (3 mm) gap between the screwhead and the wall.
Note: If you are drilling into a wall where no studs are available, use the proper anchors (3)
to secure screws. Drywall anchors have been provided for this purpose.
Step 3
Requires:
Installation Screws (2) and Shelf (1)
Slide shelf down onto mounting screws until screw heads fit snugly into keyholes. If unit is not
flush to the wall after installation: remove shelf, tighten mounting screws slightly, and re-install.
Repeat as needed.
3
2
1/8” (3 mm) gap
3
A
S
S
E
M
B
LY