Canvas Abbotsford 064-4015-0, Руководство по сборке

Страница: 50 / 104

ABBOTSFORD MEDIA FIREPLACE
50
PROBLEM
Using the fireplace with the heater
ON causes a trip in my power
circuit.
The unit does not turn on.
There is a visible flame effect, but
the heater does not continue to
blow warm air after repeatedly
turning on the heater. The heater
continues to automatically shut
itself off after a few minutes.
The heater does not work, but the
power and heater switches are in
the “ON” position.
Remote control is not working.
SOLUTION
• Fireplace is not to be used with a power strip or
extension cord. Make sure your unit is plugged by itself
into a standard qualifying wall outlet that is properly
grounded.
• Check that the unit is fully plugged into a standard 120
V outlet.
• Press the power button on the control panel.
• Turn on/off the Heater button several times to make
sure it is in the “ON” position.
• Make sure that the Demo Mode is turned off.
• To deactivate Demo Mode, press and hold the power
button for 10 seconds.
• Turn off fireplace and unplug the unit from the
wall outlet for 5 minutes. After 5 minutes, plug the
unit back into the wall outlet and operate as normal.
Make sure that no objects are blocking the air vents
on the back and on the front of your fireplace.
• Change the remote battery.
• Operate remote transmitter at a slow measured
pace. Repeatedly pressing buttons in rapid succession
may cause the transmitter to malfunction.
• Press the remote control buttons with an even motion
and gentle pressure.
• Stand closer to your fireplace.
• Remove objects that may block your remote control’s
ability to communicate with your fireplace.
TROUBLESHOOTING