Canton Smart Amp 5.1, Руководство пользователя

Страница: 28 / 67

3 97
English
5
Use the "+" resp. the "–" key to select the desired function:
Off [OFF] means that the bass signals are played through the front speakers Front Left and Front Right.
Parallel [PAR] means that the subwoofer plays the bass signals additionally to the front speakers
Xover [XOV] means that the bass signals below the set crossover frequency Stereo Sub Xover are played through the subwoofer
6
Confirm and exit the menu item by pressing the "M" button.
Stereo Sub Xover [SSX]
With this menu item you can set the frequency at which the audio signal is split into the signal for the subwoofer and the signal for the
front speakers in the Sub Stereo Mode "Xover". This menu item is only available if the Sub Stereo Mode is set to "Xover".
To adjust the crossover frequency between subwoofer and front speakers please do the following:
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate into the menu Speaker Setup [SPS] and confirm with the "OK" button.
3
Use the " " or " " button to navigate into the menu Subwoofer Setup [SUB] and confirm with the "OK" button.
4
Use the " " or " " button select the menu item Stereo Sub Xover[SSX] and confirm with the "OK" button.
5
Change the setting using the "+" or "-" key between 40 Hz [40] and 100 Hz [100] and confirm with the "OK" button.
6
To exit the menu, press the Menu button "M".
Room Height [RHE]
To get an optimal spatial impression (3D sound) during the playback of Dolby Atmos® bitstreams, the setting of the room height is necessary.
The room height can be set up to 9.90m in 0.1m steps, with 2.5m being the factory setting.
To set the room height please do the following:
1
To enter the menu, press the "M" button.
2
Confirm the first menu item Speaker Setup [SPS] with the "OK button.
3
Use the " " or " " button to select the menu item Room Height [RHE] and confirm with the "OK" button.
4
Use the "+" resp. the "–" key to set the desired height.
5
Confirm and exit the menu item by pressing the "M" button.
Device Heights [DHE]
In case of using Dolby Atmos® enabled speakers that direct the sound upwards to the ceiling it is necessary to set the heights of these
speakers (for example when placed on top of normal speakers or on a nearby surface) to achive an optimal spatial surround impression (3D
sound). The heights can be set in 0.1m steps for the front and rear "Upfire" speakers seperately, with 1m being the factory setting.