Innovative Lighting Products
Followspot Operating Instructions
V 1.1 4/19/22
6
1092 West Atlanta Street, SE • Suite 600 • Marietta, GA 30060 • 888-252-5912 •
• cantousa.com
4. MOUNTING THE IRIS DIAPHRAGM:
The iris diaphragm supplied with the followspot has 20 leaves to size the beam from a maximum aperture of 68mm to a
minimum of 5mm. A black-out iris diaphragm is available to special order.
1. Using a Phillips screw-driver remove the two phillips screws from the sides of the iris plate.
2. Slide the diaphragm in the gate area.
3. Tighten the screws.
IMPORTANT NOTICE: DO NOT LEAVE THE IRIS CLOSED FOR OVER 5 MINUTES WHILE THE LED IS ON
FAILURE TO COMPLY WITH THE ABOVE NOTICE MAY CAUSE THE IRIS AND THE FOLLOWSPOT TO SUFFER
MAJOR HEAT DAMAGE AND WILL INVALIDATE THE PRODUCT WARRANTY.
5. SHUTTER BLADES:
Shutter blades are not supplied with the unit, but are available as a separate accessory. They are sold as single items and
the relevant part number is R80208019. 4 are required.
6. ADJUSTING THE YOKE:
This followspot is provided with a yoke balancing adjustment. The balancing point is factory set for a standard usage of
the product configuration supplied (without color); however, should you need to adjust the balancing, please proceed as
follows:
1. The followspot must be mounted on the tripod stand with all relevant accessories attached.
2. Using a Phillips screw-driver, loosen the 2 (M5) screws on each side of the mounting plate of the yoke.
3. Gently slide the followspot backward or forward to the required position.
4. Make sure the yoke is correctly aligned horizontally.
5. Tighten the 4 5mm screws.