Grand Soleil 45’
- -
87
Engine starting instructions
Before starting the engine and especially after a long period of inactivity, check the
cooling liquid and both engine and reverse gear oil levels. Then, do as follows:
•
Open the sea water tap for the engine cooling system, located on the port side of the reverse
gear (see diagram at page 90).
•
With the accelerator/reverse gear single lever in vertical position, pull out horizontally the
control lever central hub and rotate the lever 1/3 turn forward to slightly accelerate (see page
86).
•
Insert the key in the engine control panel and rotate it clockwise; when in
ON
position, the
warning lights will light up; if you go on turning the key, up to
START
position,
you will
start the starter which, consequently, will start the engine.
•
To put the engine in gear you must first take the lever back to the vertical position, and then
lift the black upper part of the handle. In this position, rotating the remote control lever
forward or backwards you will put the engine respectively in gear or in reverse and you will
accelerate at the same time.
•
Before putting the engine in gear, it is a good rule to warm it up in neutral for some minutes
at 1200 – 1400 revs a minute.
•
Once started, make sure that the engine cooling water flows out through the exhaust pipe
located in the transom, on the port side.
Running-in
•
Please read the instructions provided in the builder’s use and maintenance booklet
delivered separately.
•
Do not push the engine to its limits for long periods, especially for the first 25 hours
of functioning.
•
Do not subject the engine to stress when it is cold.
•
After the first hours of engine functioning, as indicated in the use and maintenance manual,
contact the builder’s assistance for the first overhaul.
Содержание Grand Soleil 45'
Страница 1: ...Grand Soleil 45 Owner s Manual 2003...