5
3.
After wire connection is complete turn the drive motor on
momentarily to check if it is on the proper direction.
4.
Run the machine without cutting for a short period of time to
check if that all powered functions are operating properly.
Belt Adjusting
Remove the three knurled nuts and the belt guard for accessing to
the drive motor. Lower the motor mount plate on the adjustment
screw for desired belt tension. Counter lock adjusting screws (B)
See Fig. 3
NOTE: PLEASE CHECK THE V-BELT TENSION
AFTER THE FIRST TWO DAYS OF
OPERATION. BELTS WEAR DURING
INTIAL OPERATION.
Fence Installation
Install the fence on the jointer with the provided 1/2” (12.7mm)
cap screws and washers (A) as shown in Fig. 4
Fig. 2
Fig. 3
Fig. 4
ADJUSTMENTS AND OPERATION
WARNING
Disconnect machine from the power source before adjusting this
machine.
Fence Adjustment
Adjusting fence angles, (refer to Fig. 5)
1.
Loosen handle (B), hold knob (C) to open an iron plate at 90
degree.
2.
Pull fence (A) backward to obtain the required angle.
3.
Locking handle(B). Limitation of fence tilting backward is at
the 135° positions. Screw (E) as shown in Fig. 5 is for
stopping the fence tilt.
4.
The fence is at the stop of 90°; adjust screw (F) for vertical
position.
5.
Two screws (G) under sliding support are for tilting forward
to 45° position as shownin Fig. 5.
Adjusting fence forward / backward
1.
Loosen handle (H) Fig. 5
2.
Adjust handwheel (I) to meet the position required.
3.
Lock handle (H) to fasten fence.
Fig.5
