MAPMINI
Page 10 of 28
Installation Manual
September 2021 • Rev. 1.4
Panel Installation
CONTROLLER POWER CONNECTION
Note:
See Note 1 in Appendix section for suggested power supplies & backup battery.
The MAPMINI requires an external battery backed-up 12 VDC power supply.
However, it may be more cost effective to use a separate power supply (battery
backed-up) just for the MAPMINI Controller and a separate power supply which
can be sized to supply the amount of current that the attached high-current device
e.g. lock will require.
Figure 5
Mode Indicator
:
After a complete power up the SHUTDN LED on the unit flashes green waiting for a
host connection and stays steady green when a connection is established. MAPMINI
emits beep to indicate its operating mode.
1 Beep
–
First Access
2
Beeps
–
Webster
3 Beeps
–
CloudACS
Note: Continuous beeps indicate power issue. Refer to
Power Issue section for more information
