11. Power cord - it is necessary to pay particular attention to a power cord, it must be
positioned so as to avoid stepping on it and to ensure it is protected against mechanical
damage.
12. The longer the period during which you do not use the amplifier – you should disconnect
the power cord from the mains supply, or at least turn off the main power switch located on
the rear panel.
13. Subjects containing liquid - do not place these objects (vases, flower pots), so that they
can fall on the amplifier, possibly a fluid could leak out of them on the amplifier.
14. Damage requiring service - equipment should be repaired only to qualified service once:
a) power cord is damaged
b) the device fell into the water or was poured
c) the device was exposed to rain
d) the device works incorrectly
e) the device fell to the ground or is otherwise mechanically damaged.
15. Repairs - all repairs must be entrusted to qualified service.
16. General warning - use the device only in accordance with the instructions.
Caution! To help you avoid an electric shock, do not expose the amplifier to
rain or moisture
Connecting the speakers and signal cables
Input connectors are located at the rear of the amplifier and correspond to the position of the
selector switch on the front of the unit as shown here
⊳
Input - Input
(located at the sides of
the backlighted CANOR logo). Input change to select either whereby buttons or remote
control.
All inputs use RCA connectors and are connected by the usual rules, thus right channel-
RED, left channel-WHITE. On the output RCA connectors labeled TAPE OUT, you can
connect the recording equipment, for instance tape recorder, MiniDisc, etc.
The CANOR TP106 VR does not have input suitable for turntable pickup, it is necessary to
use a separate phono preamplifier, for example CANOR TP 305, which is then connected
between the turntable and a free line level input of the amplifier. For further information
contact your dealer please.
Speaker outputs are made up of two pairs of gold-plated speaker terminals labeled OUTPUT
+ and -.
Output transformer is optimized to connect the speakers with nominal impedance 4 to 8 ohms.
These connectors are located at the rear of the amplifier. Ensure that the polarity is observed
and matches the speakers.
Caution! Make all connections only if the device is disconnected from the
mains
