Canon
varioPRINT 6000 TITAN Series Customer Expectations Document
Revision 4
varioPRINT 6000 TITAN Series Customer Expectations Document
Page 14
2.6.2 Output Accessories
•
iCMU (Integrated Camera Mounting Unit-B1)
•
High Capacity Stacker 2.1 (One High Capacity Stacker is mandatory
(standard)); (two additional High Capacity Stackers (optional) can be attached
for a maximum of three)
•
High Capacity Stacker with Set Finisher
•
Media Enhancement Module (MEM)
•
PrintGuard IV (Standard on the TP TITAN and MICR TITAN models)
•
BGB3202 Perfect Binder (Requires the DFD2 Interface Kit and Lower Output
Kit for 860mm height)
•
Booklet Maker BLM6200
•
Booklet Maker , optional Book Stacker (A high-capacity stacking
system for the ), and optional P2T Two-Knife Trimmer (a 2-knife
trimming device that cuts the top and bottom edges from a booklet)
•
Booklet Maker BLM6300
•
GBC Power Punch
•
PowerLift
•
Videk DocuVision Edge
IMPORTANT
•
The Set Finisher cannot be purchased separately and installed after purchase.
•
Only one (1) Set Finisher can be a part of a configuration, and it must be
installed on top of the first High Capacity Stacker.
•
The PowerLift is used only with the High Capacity Stacker 2.1.
8 When the Set Finisher is installed on the varioPRINT 6270 TITAN machine, all sheets printed to the Set Finisher
are printed at the varioPRINT 6220 TITAN print speed (216 sheets per minute).
9 Only one High Capacity Stacker with Set Finisher is supported per configuration.
10 The MEM and PrintGuard IV cannot be installed in the same configuration.
11 Requires a combination of two units.
12 Formerly named the BLM200.
13 Requires the optional iCMU (Integrated Camera Mounting Unit-B1).
