Chapter 3
3-37
3) Remove two screws [1], open three harness
retainers [2], and disconnect two connectors [3].
F-3-147
4) Lift tray 1 [1] to remove it.
F-3-148
When installing the tray, be careful not to twist the
tray cable. To prevent the gear phase from shifting
due to the front and rear rails, the tray must be
attached horizontally. Lower the tray [1] to the
position shown in the figure and compare the
heights of the shutter guide top edges [2] with those
of the tray projections [3] at the front and rear to
check that the tray is attached horizontally. If their
heights are not the same, remove the tray and then
attach it again.
F-3-149
3.3.3
Tray 2
3.3.3.1
Removing the Front
Door
0009-4457
1) Open the front door [1] and remove the clip [2].
2) Lift the front door [1] to remove.
F-3-150
3.3.3.2
Removing the Rear
Upper Cover
0009-3609
1) Remove four screws [1] and remove the rear upper
cover [2].
[3]
[2]
[1]
[2]
[3]
[1]
[1]
[1]
[3]
[2]
[1]
[2]
Содержание Saddle Finisher-T2
