Canon Saddle Finisher-AF2, Руководство по обслуживанию, Страница: 118 / 244

Chapter 4
4-8
4.2.5 Stack Wall (Upper)
4.2.5.1 Removing the Stack Wall (Upper)
0020-8345
1) While holding the tray from the below, insert the driver [2] to the hole [1]
in the lower side, release the cam [3] as the direction of the arrow [A], lift
down the tray as the direction of the arrow [B] to the position that it does
not touch the stack wall (upper).
F-4-28
2) Remove the stack wall (upper) [1].
- 4 screws [2]
F-4-29
4.2.6 Stack Wall (Lower)
4.2.6.1 Preparation for Removing the Stack Wall (Lower)
0020-8346
1) Remove the stack wall (upper).
(page 4-8)
Reference[Removing the
Stack Wall (Upper)]
4.2.6.2 Removing the Stack Wall (Lower)
0020-8347
1) Open the front cover.
2) Remove the stopper (middle) [1].
- 1 screw [2]
F-4-30
3) Lift tray A and tray B in the position upper than stack wall (lower).
4) Lower the shutter [1], remove 2 screws [2].
5) Remove the stack wall (lower) [3].
- 4 screws [4]
F-4-31
4.2.6.3 Install the Stack Wall (Lower)
0020-8348
1) Rotate the shutter drive shaft [2], hence the shutter drive roller [1] can
move down.
[1]
[A]
[B]
[2]
[3]
[1]
[2]
[2]
[1]
[2]
[4]
[3]
[1] [2]