![background image](http://html1.mh-extra.com/html/canon/realis-wux5000/realis-wux5000_user-commands_4200477055.webp)
WUX5000 / WUX4000 User Commands
- 52 -
POWER
This controls the power supply
Format
POWER
□
<Parameter:ID>
GET
□
POWER / ?
△
POWER
<Parameter:ID>
ON Power
ON
OFF Power
OFF
Environment
Power
Input
OFF ON
PM
D-RGB A-RGB
COMP
HDMI
None
- -
Response
"i:OK" is returned if the parameter was set properly.
For '
GET POWER
' or '
?POWER
', current power supply status is returned as shown in the table below.
Response
Status
'g:POWER=OFF' OFF
'g:POWER=OFF2ON'
OFF -> ON in transition
'g:POWER=ON' ON
g:POWER=ON2PMM'
ON -> Standby in transition
'g:POWER=PMM' Standby
'g:POWER=PMM2ON'
Standby -> ON in transition
'g:POWER=ON2OFF' ON
-> OFF in transition
For details on other responses, refer to the "Error List".
Description
(1) This performs ON / OFF control of the power supply.
(2) This command is identical to pressing the POWER button on the remote control.
(3) Processing of other commands (including ZOOM / FOCUS) will be interrupted at "POWER
OFF" when the power is ON.
(4) 'i:BUSY' will be returned at "POWER ON" during power OFF transition. For other cases,
'i:OK' will always be returned.
(5) The current power supply status can be referenced using the applicable GET command. ("
GET POWER
")
(6) After sending this command, use GET POWER to obtain the power supply state at regular
intervals, and check that it is in the controlled state (off or on).
(7) Even when it is powered up by using this command, "Prepare for lamp replacement", "Lamp
replacement warning", "Clean filter warning" will display for 10 seconds as usual.
Example
Control
> POWER ON
< i:OK
Reference
> GET POWER or ?POWER
< g:POWER=OFF
* Commands are indicated by ">", and responses are indicated by "<".