Install the air filter to the air hole, the fat end going down.
Fold a piece of paper, insert it to the lid switch hole to touch the sensor , so the printer will think the lid is closed and
ready to print.
Check the printing head. Run Nozzle check.
If it shows breaks, please clean your printing head. It is possible that the wispy air have entered into the printing head. If
it is still showing little breaks especially in one color, there is no need to repeatedly continue to clean. Just keep the
printer silent for about one hour, it will disappear.
If there are still some bubbles in the tube after installing the system correctly, just run head cleaning 1-3 times, (do not
clean over 3 times, because it might cause ink flood on your bottom of printer. If still have some air bubble in the tube,
just wait a few hours, then do the head cleaning again. The bubble will be gone after that.
After the bubble gone, let the printer sit there for a few hours before print anything, the quality will be good by then, if
printing quality is good, please don’t need care about the air bubble in the tube, it will be gone after some printing.
Reset Procedure:
If the indicator light flashes when printing, it tells you that you need to change the cartridges. Please power off the
printer for about 1 minute and turn on again, this time it will show full on the computer. It should then work in good
condition.
Please pay attention to the ink level in the reservoirs; if the ink level is below 1 inch please use refill kits to fill ink into
Reservoir bottles.
Carefully pull out the big rubber plugs from the refill holes. (There is possibility of ink spattering. Be careful!) Refill ink
according to the color in short supply. Then put the rubber back. (
Please keep the printer and the reservoir at the same
horizontal line
during the process of refilling ink
.)
