Chapter 9
141
Troubleshooting
Repeated Errors Occur When You Send a Fax
Telephone Problems
Cannot Dial
Telephone Disconnects During a Call
Problems Scanning
Scanner Won't Work
ScanGear MP Won't Start
The document is not loaded with the
side to be scanned face down.
When loading the document on the Platen Glass, the side to be scanned
should be face down. When loading in the ADF, the side to be scanned
should be face up.
You are scanning thick (max. 10 mm
/ 0.39") or curled documents.
Press on the Document Cover with your hand when scanning.
Cause
Action
The telephone line condition or
connection condition is no good.
Reduce the transmission start speed (See
). If there is a poor line or connection, reducing the transmission
start speed may correct the error.
Cause
Action
The telephone line is not correctly
connected.
Check that the telephone line is correctly connected (Refer to the
Easy
Setup Instructions
).
The telephone line type is not set
correctly.
Make sure the machine is set for the correct telephone line type (See
“Setting the Telephone Line Type” on page 62
).
Cause
Action
The power cord, the telephone line,
or the telephone (or another external
device such as an answering
machine or a computer modem) is
not connected securely.
Check that the power cord, the telephone line, and the telephone (or
another external device such as an answering machine or a computer
modem) are connected securely.
Cause
Action
The machine is not recognized by
the computer.
Restart the computer.
This may enable the computer to recognize the machine.
Cause
Action
Scanner driver (ScanGear MP) not
installed.
Set the Setup CD-ROM and install the software.
Cause
Action
