6
14) Put all the parts that you have removed back in
place.
- cable guide
- soft ID cable
- IP-LAN cable (if a UFRII LT PRINTER KIT-J2
is mounted)
15) Attach the LAN cover removed in step 7-1).
(if a UFRII LT PRINTER KIT-J2 is mounted)
When attaching the LAN cover, take care not to
damage the grounding plate [2] by the LAN port [1].
Also, after attaching the LAN cover, check to make
sure that the grounding plate is in firm contact with the
LAN port.
F-1-15
16) Mount the 256MB RAM [1].
F-1-16
17) Put back the parts that have been removed.
- RAM cover
- the connector of the IP-modem cable (if a Super
G3 Fax Board-T1 is mounted)
- rear left cover
- rear cover
18) Connect the power plug, and turn on the main
power switch.
1.2.2 Checking the
Connection
When you have installed the kit, go through the
following to make sure that it is properly recognized:
1) Start service mode.
User Mode key > 2 > 8 > Use Mode key
In response, [#SSSW] appears.
2) Press [
] 5 times. When [REPORT] has
appeared, press [OK].
3) Press [
] once. When [REPORT OUTPUT]
has appeared, press [OK].
4) Press [
] 5 times. When [SPEC LIST] has
appeared, press [OK].
5) See that a SPEC REPORT is printed out. Check to
be sure that 'PCL' is 'ON'.
[1]
[2]
[2]
[1]
All manuals and user guides at all-guides.com
all-guides.com
