Canon Oce TDS Series, Руководство администратора

Страница: 39 / 138

Enable SMB protocol
Introduction
IMPORTANT
The following information and procedures do not address all the Océ TDS/TCS systems.
Indeed, the SMB settings configuration is not applicable to the Océ TCS500 v1.2 and higher, Océ
TCS300, Océ TDS7x0 and Océ TDS450 v3.1 and higher.
This section presents the list of the SMB functionalities, and the procedures to configure the SMB
settings.
SMB functionalities
Depending on the Océ print system and Océ PLC controller release, you can find the following
SMB functionality:
(2) SMB capabilities
Océ Print System Océ TDS3x0
Océ TDS400
Océ TDS600
Océ TDS8x0
Océ TCS400 Océ TDS450 v3.0.x
Océ TCS500 v1.1.1 Océ TDS7x0
Océ TDS450 v3.1 and
higher
Océ TCS500 v1.2 and
higher
Océ TCS300
Functionality
SMB browsing
YES
(1)
YES
(2)
NO
SMB Point and Print
YES
(1)
NO NO
Limitations:
•
(1) For ‘Standard / Normal’ security level only.
•
(2)
SMB browsing functionality is of limited interest as Point and Print is not available.
NOTE
You MUST be logged on as a system administrator.
Enable SMB printing protocol
Procedure
1. Switch the Océ Settings Editor in SA Mode on page 128
.
2.
Select ‘Connectivity’ - 'SMB' - 'Enable SMB'
Enable SMB protocol
Chapter 2 - Configure the print system controller 39
Océ TDS/TCS/TC Connectivity information for Windows environments