67
Advanced
Operation steps
1 Power on your projector.
2 Acquire the IP address, with DHCP set to on and
auto IP allocation set to On. (You may set DHCP
to Off and set up IP address manually.)
3 Enter the network setup menu
(1) Press MENU button on remote controller or
top control panel, press
button to select
network icon.
(2) Press
button select network settings and
press OK button to enter.
MAC address......Display the MAC address
of wired network.
IP address...........Display the IP address of
wired network.
(3) Press
button to set DHCP On to obtain
an IP address, subnet , gateway and DNS
automatically , and press OK button to
confirm.
Press
button to set DHCP Off,then
press OK button to enter an IP address,
then press
button to select subnet ,
gateway and DNS automatically.And press
OK button to confirm.
7C:6F:F8:4E:B9:2F
192.168.1.100
Network
Network setting
Network information
MAC address:
IP address
Advanced
Network menu
Preparation
1 Required equipment: Projector, computer, network cable
2 Connection:
Connect your projector to a router or switch in the LAN with normal or jumper network
cable. In case a normal network cable failed to connect successfully, use a jumper cable
instead.
3 Turn on the computer. The LAN port on computer and projector are flashing after power
on the projector.
Function:
This function is designed to allow the computer control the projector remotely via
intranet.
Network
：
Move
：
Next
OK
：
Back
MENU
LAN
DHCP
IP address
Subnet
Gateway
DNS
Network setting
Set
On
Cancel
. . .
. . .
. . .
. . .
：
Move
：
Next
OK
：
Back
MENU
Off
192 . 168 . 1 . 100
255 . 255 . 255 . 0
192 . 168 . 1 . 1
192 . 168 . 1 . 1
LAN
DHCP
IP address
Subnet
Gateway
DNS
Network setting
Set
Cancel
Factory default
This function resets all your settings to factory default .
1) Press
button to select [
F
actory default] menu.
2) Press <OK or > button.
3) Press
button to select YES ,then press <OK>
button.
Return to factory default?
Yes
No
：
Move
：
Back
MENU
OK
：
Select
