iR6570-013
(3/5)
4. Prepare the Primary Fan Duct, affix two-sided tape to the Duct as shown in [5] and then remove the release paper
from the tape.
Note: Affix two-sided tape to the position as shown in [6], not lying off the edge of the mold and within 0.5mm from
the edge (OK for extending onto the molt plane).
5. Mount the Primary Fan Duct on the copier with two screws. First, set the Duct [7], hitch two rear Claws of the
Duct to two positions [8] and pull the Duct frontward.
[6]
Unacceptable of lying off edge of mold / Within 0.5mm from edge
