Canon iR1210, Руководство по обслуживанию

Страница: 327 / 424

COPYRIGHT © 2002 CANON INC. 2000 2000 2000 2000 CANON iR1200/iR1300 Series REV. 0 AUG. 2002
7-23
CHAPTER 7 TROUBLESHOOTING
Connector
7) Is the connection of the following connectors normal: J201 and
J204 on the DC controller PCB; J303, J304, J312, and J316 on the
image processor PCB; J3122 and J801 in the laser scanner unit?
NO: Connect them firmly. If a scratch is found in the flexible cable, re-
place it.
Drum unit
8) Try replacing the drum unit. Is the fault corrected?
YES: End.
Developing unit
9) Try replacing the developing unit. Is the fault corrected?
YES: End.
Laser scanner unit, DC controller PCB
10) Try replacing the laser scanner unit. Is the problem corrected?
YES: End.
NO:
Replace the DC controller PCB.
Transfer guide
11) Measure the transfer guide and other metal portions. Is the resis-
tance 0
Ω Ω
Ω Ω Ω
YES: Check the area around the toner guide for a piece of metal (e.g.,
screw).
High-voltage contact (between transfer charging roller and high-voltage spring)
12) Is the high-voltage spring used to supply high voltage to the trans-
fer charging roller soiled?
YES: Clean it.
High-Voltage Contact (high-voltage spring and DC controller PCB; J209), Transfer charging
roller
13) Is the connection between the high-voltage spring and DC control-
ler PCB (J209) normal?
YES: Replace the transfer charging roller.
NO:
Correct it. If it cannot be corrected, replace the faulty part.
Selfoc lens array (contact sensor)
14) Clean the selfoc lens array of the contact sensor. Is the problem cor-
rected? (See 4.3.1 of Chapter 6.)
YES: End.
Contact sensor LED intensity auto adjustment
15) Execute contact sensor LED intensity auto adjustment. Is the prob-
lem corrected? (See 1.2.4.1 of Chapter 7.)
YES: End.