5
When printhead adjustment ends, paper is
printed with an adjustment pattern and is
ejected.
While holding the paper, press the release
lever (a) backwards to remove the paper.
9
a
Load paper for adjusting the printhead into the printer.
Follow these steps to load cut sheet paper into the printer. The sample paper provided is used in this example.
Load Cut Sheet Paper
Return unused paper to the pouch it
came in, and store it away from heat,
humidity and direct sunlight.
•
Slide the width guide (a) and align it
with the mark for the size of paper to be
loaded. In this example, align the width
guide with A2 to align it with the size of the
sample paper.
Select type of paper for printhead adj.
is shown on the display screen. Check
that
Cut Sheet
is selected and press
OK
.
Instructions on loading cut sheets are
shown on the display screen.
Prepare one sheet of paper.
Refer to the packaging for the paper to
check which side is the printable surface.
1
2
a
3
Only one sheet can be loaded in the
printer. Do not load two or more sheets.
Doing so might cause a paper jam.
•
Wrinkled or warped paper might cause
paper jams. Be sure to
fl
atten the paper
out before loading it.
•
Load paper with the printable surface
face up.
Insert the paper until its leading edge
touches a stop and you hear a tone.
4
A message con
fi
rming paper advance is
shown on the display screen. Press
OK
.
6
Pull the release lever forward.
Printer setup is now complete.
For how to load roll paper, refer to the
Basic
Guide
(1), to the
User Manual
installed
at "Install the Printer Driver and the User
Manual", or to the instructions displayed by
the navigation function of the control panel.
•
Follow the procedure below to display the
navigation on how to load roll paper.
1. Press
Navigate
.
2. Use the
▲
and
▼
keys to select
Load Roll
Paper
and press
OK
.
3. Use the
▲
and
▼
keys to select
View Op.
Guide
and press
OK
.
The navigation starts.
MEMO
10
The screen for selecting the paper type is
shown on the display screen. Press
▲
or
▼
to select the type of paper loaded in the
printer.
Select
Coated Paper
and press
OK
.
Then from the menu that appears, select
Coated Paper
and press
OK
.
7
The paper is advanced.
MEMO
During printer installation, ink
fi
lls the system
between the ink tanks and printhead . In
addition, printheads are cleaned to keep the
printer in optimal condition. This may cause
the maintenance cartridge capacity indicator
to drop to about 80%, but this is not a problem
with the printer.
When paper advance ends, the system
is automatically
fi
lled with ink for the
fi
rst
time and printhead adjustment is started.
It takes a total of about 20 minutes.
Make use of this time by referring to
"Install the Printer Driver and the User
Manual" on page 6 to install the printer
driver and the User Manual on your PC.
8
Adjust the position of the width guide (a)
to the size of the paper to be loaded.
Make sure the width guide
fi
ts properly
against the edge of the paper to prevent it
from being tilted or wrinkled.
5
a
