*1: Only for models supporting CD / DVD printing
*2: Only for models not supporting CD / DVD printing
2-2. Service Call Errors (by Cyclic Blinking in Orange (Alarm LED) and Green
(Power LED), or Alarm LED Lit in Orange)
Service call errors are indicated by the number of cycles the Alarm and Power LEDs blink, and the corresponding
error code is displayed on the LCD.
The remaining ink
amount unknown.
[1683]
(Applicable ink tank icon)
The remaining level of the
following ink cannot be correctly
detected.
An ink tank which has once been
empty is installed. Replace the
applicable ink tank with a new
one.
Printing with a once-
empty or refilled ink
tank can damage the
print head.
If printing is continued
without replacing the
"no-good" ink tank,
press the Stop/Reset
button for 5 sec. or
longer to record the use
of a refilled ink tank.
Note:
After the above
operation, the function
to detect the remaining
ink amount is disabled.
Ink tank not recognized.
[1684]
(Applicable ink tank icon)
The following ink tank cannot be
recognized.
A non-supported ink tank is
installed (the ink tank LED is
turned off). Install the supported
ink tanks.
Ink tank not recognized.
[1410 to 1419]
(Applicable ink tank icon)
The following ink tank cannot be
recognized.
An error occurred in an ink tank
(the ink tank LED is turned off).
Replace the ink tank(s).
Access cover open.
[1200]
Cover is open. Close the cover.
Close the access cover.
Cycles of
blinking in
orange
(Alarm
LED) and
green
(Power
LED)
Error [Error code]
Conditions
Solution
(Replacement of listed parts,
which are likely to be faulty)
2 times
Carriage error [5100]
An error occurred in the carriage encoder
signal.
- Carriage unit (QM2-2298)
- Timing slit strip film
(QC1-6394)
- Logic board ass'y (QM2-
2745)
*1
- Carriage motor (QK1-
1500)
3 times
Line feed error [6000]
An error occurred in the line feed signal.
- Timing sensor unit (QM2-
2683)
- Timing slit disk film
(QC1-6229)
- Feed roller ass'y (QL2-
0925)
- Platen unit (QM2-2313)
1-7
Содержание iP6600D - PIXMA Color Inkjet Printer
