Canon ImageRunner 2030i, Справочное руководство, Страница: 82 / 412

Making Prints Using the Stack Bypass 2-29
2
B
a
si
c O
p
e
ra
tio
ns
Making Prints Using the Stack Bypass
If you are making prints on labels, transparencies, or nonstandard paper size stock,
load the paper stock into the stack bypass.
IMPORTANT
•
Note the following points when using the stack bypass:
- Paper Quantity: one to approximately 80 sheets (22 lb bond (80 g/m
2
), stack
approximately 1/4" (5 mm) high)
- Paper Size: 3 3/4" x 5 7/8" to 11 3/4" x 17" (95 mm x 148 mm to 297 mm x 432 mm)
- Paper Weight: 17 to 32 lb bond (64 to 128 g/m 2 )
- Paper which has been rolled or curled must be straightened out prior to use, to allow
the paper to feed smoothly through the stack bypass (allowable curl amount: less than
3/8" (10 mm) for normal paper, less than 1/4" (5 mm) for heavyweight paper).
- Depending on the paper storage conditions, it may not be possible to feed some paper
into the stack bypass. In this case, set the amount of paper to less than 40 sheets
(80 g/m
2 ).
•
Do not load different size/type paper at the same time.
•
Depending on the type of heavyweight paper you want to load, if you load multiple sheets
of heavyweight paper into the stack bypass, a paper jam may occur. In this case, load
only one sheet of heavyweight paper at a time.
•
When printing on special types of paper, such as heavyweight paper or transparencies,
be sure to correctly set the paper type, especially if you are using heavyweight paper. If
the type of paper is not set correctly, it could adversely affect the quality of the image.
Moreover, the fixing unit may become dirty and require a service repair, or the paper
could jam.
•
If you are printing on envelopes, do not allow more than 10 envelopes to accumulate in
the output tray. Always empty the output tray once 10 envelopes have accumulated.
•
If you select [Irreg. Size] for copying, you cannot use the Rotate Collate, Rotate Group,
Offset Collate, Offset Group, Staple, 1 2-Sided, 2 2-Sided, Book 2-Sided, 2-Page
Separation, or Image Combination mode. (See Chapter 1, “Introduction to Copying,” in
the
Copying Guide .)
•
If you select [Envelope] for copying or printing, you cannot use the finishing modes,
1 2-Sided, 2 2-Sided, Book 2-Sided, 2-Page Separation, or Image Combination mode.
(See Chapter 1, “Introduction to Copying,” in the
Copying Guide .)