Canon imagePROGRAF iPF820, Руководство пользователя, Страница: 673 / 702

Messages regarding paper
Paper cutting failed.
Cause Corrective Action
There are sheets left on the Ejection Guide.
1.
Lift the Release Lever and remove the paper.
2.
If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
There is a foreign object by the Output Tray,
obstructing the Cutter Unit.
1.
Lift the Top Cover and remove the foreign object.
2.
If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
You are not using the printer under the recommended
environmental conditions for the paper. Use the printer only where the recommended
environmental conditions for the paper are met.
Note that various environmental conditions are
recommended for various types of paper. For details
on the recommended environmental conditions for
paper, see the Paper Reference Guide.
(→P.104)
You are using paper that is not compatible with
automatic cutting. Specify Manual as the cutting method and cut the
roll manually.
(→P.139)
For information about paper that is compatible with
automatic cutting, see the Paper Reference Guide.
(→P.104)
The Cutter Unit stops in the middle of cutting. If the Carriage is out, move the Carriage out of the
way, away from the paper.
If the Cutter is out, move the Cutter to the right side
(away from the paper) and remove the jammed paper.
(→P.131)
If the paper cannot be cut using the Cutter Unit,
specify
Manual as the roll cutting method and cut
the roll manually.
(→P.139)
In other cases, the Cutter Unit may be damaged. Contact your Canon dealer for assistance.
End of paper feed.
Cause Corrective Action
You are pressing the ▲ button on the Control Panel
and trying to rewind the roll to the edge.
Release the ▲ button.
Rel lever is in wrong position.
Cause Corrective Action
Lower the Release Lever. The Release Lever is up.
If the error occurs again, turn off the printer and wait
a while before restoring power.
Error Message 659