Canon imagePRESS A3200, Инструкция по установке и обслуживанию

Страница: 40 / 192

I
NSTALLATION
40
Connecting to the network
Use the following procedure to connect the imagePRESS Server to the customer network.
T
O CONNECT TO THE NETWORK
1. Shut down the imagePRESS Server before connecting it to any network device (see page 51 ).
2. Obtain the appropriate straight-through Ethernet cable for the customer network connection:
• For 10BaseT link speed, use a cable that is Category 3 or higher
• For 100BaseTX, use Category 5 or higher (4-pair/8-wire, short-length)
• For 1000BaseT, use Category 5e or higher (4-pair/8-wire, short-length)
N
OTE
: Be sure to use a straight-through Ethernet cable for the network connection. To verify
the cable type, align the connectors on each end of the cable as shown in Figure 9 . On a
straight-through cable, the wire arrangements are identical on both ends; on a crossover cable,
the wire arrangements are different.
F
IGURE
9:
Straight-through and crossover Ethernet cables
3. Connect one end of the network cable to the network connector on the back of the
imagePRESS Server (see Figure 6 on page 35 ).
The motherboard in the imagePRESS Server has an external Ethernet network connector that
supports 10/100/1000 Mbps link speed.
4. Connect the other end of the cable to the customer network.
1
2 3 4
1
2 3 4
1 2 3 4 3 4 1 2
=
=
Align cable connectors side by
side and examine wires:
Straight-through cable:
wire arrangements are
identical on both connectors
Crossover cable:
wire arrangements are different
(The wire arrangement shown
here is an example; actual
arrangements may vary.)