3-6
COPYRIGHT © CANON ELECTRONICS INC. 2011
CANON P-215 FIRST EDITION
CHAPTER 3 DISASSEMBLY & ASSEMBLY
2. Top Cover
1) Remove the upper unit [whole].
2) Remove 2 screws
{
1
(self-tapping, FH
M2.5x6). Push out the end of the shaft
{
2
of the front roller (follower) and remove it.
At this time, 2 rollers
{
3
are also removed.
Figure 3-204
3) Remove the separation pad. While ex-
tending 5 pairs of the fitting parts
{
1
to the
out side in order from the end side, remove
the upper cover on the rear side.
Note:
The lock shaft, coil spring for the lock
shaft and entrance guide for card can
be removed when the upper cover is
removed.
Figure 3-205
Notes on assembling
After assembling the upper cover, be sure
to fasten the 2 screws.
3. Registration Roller [follower]
1) Remove the top cover.
2) Remove the start switch PCB
{
1
from the
base. Hold the registration roller on the
rear side with hand and unhook 2 pairs of
the fitting parts
{
2
of the shaft pushing
plate, remove 2 registration rollers
{
3
, the
shaft
{
4
and 2 springs
{
5
.
Figure 3-206
Notes on assembling
Bring the flat part at the center of the shaft
into contact with the end surface of the
springs.
Figure 3-207
