COPYRIGHT © 2005 CANON ELECTRONICS INC. CANON DR-2580C FIRST EDITION APR. 2005
5-11
CHAPTER 5 TROUBLESHOOTING
11. Counter
This mode is used to display/change total
count (cumulative number of feed sheet) and
display/change the number of document jams.
When [Counter] is selected on the service
screen, the counter screen is displayed.
Figure 5-218
The contents of display are as follows:
•
ADF Count
Indicates total count of the main unit.
•
FlatBed Count
Indicates the number of scan of the flatbed
unit.
•
P01_Jam Count
Indicates the number of early reach jams.
•
P02_Jam Count
Indicates the number of residual jams.
•
P03_Jam Count
Indicates the number of fast feed jams.
The “Total Count” shown at the bottom of
the service screen is the total of “ADF Count”
and “FlatBed Count”.
When the [Set] button on the right or the
[Set] on the lower right of the screen is se-
lected after the value is changed, the changed
value is determined.
To close the screen, press the [Close]
button.
These values might be changed if the
control PCB is replaced. Therefore, inputting
the values again is required after the re-
placement. If the values before the replace-
ment are not clear, it is better to input the
recommended values.
Содержание imageFORMULA DR-2580C
