DR-2010C / DR-2510C
DR-2010C / DR-2510C
21
There are two methods for feeding documents, the Page Separation mode and
Bypass mode. Feeding pages continuously from a stack of documents placed in
the feed tray is called the Page Separation mode. Feeding documents one sheet
at a time or feeding documents consisting of multiple pages that are attached, is
called the bypass mode.
The document feed method can be changed by moving the feed selection lever.
1
Switch the feed selection lever to
(Page Separation).
2
Adjust the document guides to fit the width of the document to be scanned.
3
Fan the pages of the document to be scanned, and shift them so that the
top of the first page (the bottom of the front of the document) is the lowest.
(Place the document so that the top of the document is facing down.)
CAUTION
When placing documents into the feed tray, take care not to cut your hands on
the edges of the paper.
4
Place the document with the reverse side facing you, and the top of the
document facing down.
IMPORTANT
There is a load limit mark (
) on the document guides. Do not stack
documents higher than this mark (approximately 50 sheets of 20 lb bond
(80 g/m
2
) paper.) Doing so may cause a paper jam.
Feeding in the Page Separation Mode
3. Placing Documents
3 Placing Documents
3. Placing Documents
